Install Laminate Stair Nose Moulding

And to have it set level on the edge of the stair.

Install laminate stair nose moulding.

This is accomplished by cutting the riser flush with the top of the step. The molding sits against the stair tread while overlapping the front of the step to give it a nicely rounded decorative look. Stair nose moldings pergo simple solution stairnose enhances the overall beauty of the staircase or step down while acting as a protective strip for the flooring along the leading edge. Zamma cross sawn oak grey 3 4 in.

Install the molding track by gluing screwing or nailing it 3 4 from the edge of the stair tread apply construction grade adhesive to the stairnosing where the. Stair tread gauge http amzn to 2i3slng subscrib. Install the metal track on the stair nose with the liquid nails glue. Stair nose molding is used in conjunction with a hardwood floor installation to finish off the step or stairwell where the hardwood floor stops.

Install the track just close enough to the edge of the stair nose to allow the edge of the stair case molding to hang over. Wide x 94 in. Watch installing laminate on stairs. This applies to laminate stair nose as well as hardwood stair nose.

Stair tread and nosing installation. Stairnose the stairnosing is used to finish stair treads and risers which have been fully adhered to the floor using a shaw approved multipurpose flooring adhesive stop the flooring about 1 1 2 from the step s edge. Installation is easy laying your laminate up to 1 3 4 from the edge of the step then cut the molding to the desired length glue screw in place in recommended. Thick x 2 1 8 in.

Length laminate stair nose molding 32 98. Stair nose molding is about 4 to 5 inches wide. Allow time for the glue to dry by following the guidelines on the tube of glue. The main objective when cutting stair nose molding and installing it is to cut the stair nose as tight as possible to fit on each side.