Installing Baseboard Trim Over Carpet

All you need to so now is go along that wall and fasten the remainder of the trim as you normally would.

Installing baseboard trim over carpet.

Baseboard first set on 3 8 wood lath strips tack less set between 3 8 1 2 inch away padding brought up to tack less and carpet installed and stretched over tack less and tucked under base. Baseboard installed on top of carpet should be installed at approximately the same height with this exception. This technique also leaves more of that handsome baseboard showing above the carpet. Do not push down on the baseboard so that it presses into the carpeting.

The trimmer is not going to make a special trip back to install the base after carpet is installed. Tools and supplies to install baseboards. When installing baseboards before carpet ask the installer how large of a gap to leave between the floor and the trim e g. If you are not intending to install quarter round or base shoe the baseboard should.

Fit the molding to the wall flush against the carpet. Coping an inside corner joint. A week before installation bring the wood inside to acclimate. However consult with your installer to be sure they have no concerns.

Once the trim is fastened remove the short baseboard pieces and move these along as you install the baseboard. These can be reused over and over again so hold onto them. Hammer tack nails through these holes into the wall plate. Start running baseboard against inside corners and work toward outside corners.

Try adding painters tape. Nail the baseboard in place with the sticks resting only lightly on the surface of the carpet. The carpet installer can run the tack strip up to the trim then roll excess carpet under the trim. Carpet installers prefer to cut the carpet a little long and tuck the excess into the gap for a neater job.

For most installers this is not a problem and can be done easily. The idea is that you should. This is the basic method for baseboard installation for carpet applications. If the molding is slightly long trim it at angled 1 16 inch increments from the end to fit the wall.

Steps on how to install baseboard 1. Lay them flat on the floor every few feet and then cut the base to fit rest it on the spacers and nail it into place. Then touch up base if need be. Scarf and butt joints.

Drill 1 16 inch holes every 16 inches through the baseboard angled downward toward the wall plate. To determine the amount of baseboard material you need measure each straight section of the wall and round up to the nearest whole foot dimension divisible by two.