Is The Cricut Vinyl Shiny Side Down

Use a craft stick or scraper found in the cricut tool kit to burnish rub or polish the tape onto the vinyl.

Is the cricut vinyl shiny side down.

Preparation with cricut transfer tape. It s the shinny side. Gently place the transfer tape adhesive side down over the images. Perform test cuts to get your settings correct and remember to reverse your image on your computer before cutting htv.

You want to cut through the vinyl but not through the carrier sheet. Select images and size and load the mat into the machine. Mirror the image in the design program before cutting otherwise when you flip the vinyl the cut will be backwards. Then position it plastic side down and vinyl side up the more dull less shiny side.

There is no transfer tape required with cricut iron on vinyl because it is already hooked onto the vinyl. The vinyl side goes face up. Refer to kiss cut guide below to adjust machine settings. Remove the negative pieces from each of the images leaving the clear.

So again that s shiny side down. The shiny side goes down when your cutting. Also it is why you put the shiny side down when you cut cricut iron on vinyl. Cutting vinyl with a cricut machine.

If your vinyl came on a roll you can cut off a piece to fit on your mat. Put the iron on vinyl shiny side down on the mat so you re cutting the back of the vinyl and not the carrier sheet. The iron on vinyl is put onto the roll carrier side out which means the side that curls down is the carrier side and the side that curls up is the vinyl side in the end if you re faced with two shiny sides the same color the slightly less shiny side is going to be the vinyl side. There is a layer of plastic that will be peeled away.

Cut on iron on vinyl setting. Place vinyl liner side down onto cricut standardgrip mat. The cricut cutting mats are really similar and i have used cricut mats with my silhouette. That means you are putting the shiny transfer tape on the sticky mat surface.

Here is another example shinny carrier side hard to pick through the vinyl side. Press flashing go button.